U-Boot 1.1.2 (Nov 29 2006 - 11:52:48)                                    

U-Boot code: 33C00000 -> 33C40B40  BSS: -> 33C7A408                                                  
RAM Configuration:                  
Bank #0: 30000000 64 MB                      
Get flash bank 0 size @ 0x0                          
Total Flash bank's sizes: 0x200000                                  
protect monitor 40b40 bytes @ address 0                                      
Flash:  2 MB            
NAND:64 MB          
*** Warning - bad CRC, using default environment                                                

In:    serial            
Out:   serial            
Err:   serial
[ MAC : 08 00 3e 26 0a 5b ]
clk = 133217280
pixclk 8863560, divisor is 15
CLKVAL = 6

SD Initialize fail..

Hit any key to stop autoboot:  0
SMC91111:smc_open
SMC91111:smc_phy_configure()
phy cfg reg1: 0x0022
SMC91111:phy caps=0x7809
SMC91111:phy advertised caps=0x01e1
SMC91111:PHY_STAT_REG : 0x7809
SMC91111:PHY auto-negotiate timed out
SMC91111:PHY auto-negotiate timed out
SMC91111:RPC_DEFAULT : 0x3810
[ MAC : 08 00 3e 26 0a 5b ]
Using MAC Address 08:00:3E:26:0A:5B
TFTP from server 192.168.20.1; our IP address is 192.168.20.3
Filename 'aesopk'.
Load address: 0x32000000
Loading: T T T T T T T T T T T T T T T T T T T T
Retry count exceeded; starting again

이렇게 뜨는데요

SMC91111 timed out 하고
Loading: T T T 이 부분이..

SMC는 IP를 마춰주면 될것 같긴한데요
(랜선을 연결하면
SMC91111:PHY remote fault detected
SMC91111:PHY remote fault detected
이렇게 뜨더라구요)
Loading이 안되는것은 커널이 안올라가 있기 때문인가요??

음...진짜 질문은;;;
배포해주신 3차 보드에 커널이 올라가 있지 않은것인지요?